Enviro-Line Logo
 
 
 

..........

Above Grade Package Vault Pump Station

This style of station offers the simplicity of a submersible style pump station but the
convenience of the controls and valves under the FRP hood. The FRP hood has the
appearance of a normal utility box, which makes for a neighborhood-friendly installation.

A heater should be installed under the FRP hood to keep pipes from freezing while
pipes are idle.

These stations are popular with developers and municipalities for stations with flows
of up to 500GPM pumping rate or approximately a 500-600 house development.

These are also used for retro-fitting an existing lift station where no valve vault exists,
providing a simple and neat installation.

Pump Design Details    

Size ranges: Up to 8" piping
Flows to 20-600 GPM
HP: 2HP to 50HP
Discharge Pressure: 250'
Bearing Life: 100,000 hours
Seals: Tungsten or Silicon Carbide

Motor: Class H Insulation for continuous duty
Motor: Non-overloading entire curve
Voltage: 230VAC, 1ph; 208/230/460VAC, 3ph
Impellers: Multiple styles available
Pump Cord: Multi-barrier protection to prevent intrusion
 
 

Site Design Details:
Wetwell Diameter: 5'-8'
Wetwell Depth: Up to 30'
Hoist: Manual or electric preferred
Rails: 304 Stainless Steel - sch 40 pipe
Intermediate Brackets: Over 20' wetwell depth
Guide Brackets: Dual Rail (stainless steel)
Hatch: Aluminum with spring-loaded assist
Forcemain Size: Depends on the model of pump applied

               
  Complete station with valve vault in basement and control panel at grade in air-conditioned room